Range Rover Classic

Range Rover Classic

Sort by

LT230 Gasket Kit

LT230 Gasket Kit

$21.00
Gasket kit to suit all variants of the LT230 transfer case from 1984. Suits Range Rover Classic, Discovery 1, Discovery 2 (although not usually required) and Defender/County. Includes o-rings but not oil seals (see FTC4939 and ICV100000).*** Specific...
Hub Oil Seal

Hub Oil Seal

$17.00
This is the only inner hub seal worth using on any Genuine Land Rover. This is a double lip and double spring design made especially for oil filled hubs. Fits all coil sprung live beam Genuine Land Rovers up to and including the Puma Defender. Fits all...
Wheel Bearing

Wheel Bearing

$40.00
OE Timken single wheel bearing to suit all Range Rover Classic, all Discovery 1, all Defender and 110 up to 2017, and all Perentie 4x4 and 6x6. Suits inner and outer, front and rear (2x required per hub). *** Specific Brand Part *** This product is not...
LT95 Layshaft Bearing

LT95 Layshaft Bearing

$42.20
Tapered roller bearing for the front and rear of the LT95 layshaft. Suits all versions. The preload MUST be set correctly for these bearings. Follow the workshop manual to set this correctly. DO NOT assume the existing shims are correct.    ...
Rover Diff Carrier Bearing (Late Metric)

Rover Diff Carrier Bearing (Late Metric)

$36.91
Suits front and rear Rover type diffs in Discovery 1, Discovery 2, and Range Rover Classic from approximately '92 on. Also suits front Rover diffs for Defenders from '92 on. Also suits front and rear diffs in the Range Rover P38A, and the rear diffs for...
Diff Carrier Bearing, Rover Long Nose Early Metric

Diff Carrier Bearing, Rover Long Nose Early Metric

$49.01
Usually found in post '85 Range Rover Classics. May be found in some early 110 or Defenders and some early Discovery 1. This bearing is a smaller ID compared to the later (and more common) RTC3095. *** Specific Brand Part *** This product is not specific...
Plain Wheel Nut (Steel Wheels)

Plain Wheel Nut (Steel Wheels)

$3.20
Plain steel wheel nut to suit all 110, Defender, Perentie, RRC and Discovery 1 with steel wheels. M16 thread. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we...
Front Shock Tower Retaining Ring

Front Shock Tower Retaining Ring

$7.50
Retaining ring with studs for the front shock absorber tower. With some age on these rings we are now seeing a lot of failures - usually the studs either stripping or breaking off. Suits all Range Rover Classic, all Discovery One, all Defenders, all 110...
A-Frame Ball Joint (Upper Rear)

A-Frame Ball Joint (Upper Rear)

$59.60
Non-adjustable Lemforder (German) a-frame ball joint. Top quality replacement ball joint for all Range Classic, all Defender and 110 up to 2017, all Discovery 1, and all 4x4 Perentie. For an adjustable version see RHF500110ADJ. NOTE: If you buy this with...
Adjustable A-Frame Ball Joint

Adjustable A-Frame Ball Joint

$84.00
Rear A-Frame upper ADJUSTABLE ball joint fitted to the top of the rear diff. Fits all coil sprung Genuine Land Rovers with live beam axles (all 110, Defender, Range Rover Classic, Discovery 1). The locking stakes are tapped back to allow adjustment and...
Defender/Perentie/RRC Flasher Unit - 4 Pin

Defender/Perentie/RRC Flasher Unit - 4 Pin

$59.18
4 Pin flasher unit for Defender and Perenties. Also suits Range Rover Classic (approx. '86 to '94). Compatible with trailer warning light. Not compatible with LED indicators without load resistors. *** Specific Brand Part *** This product is not specific...
Single Horn, Defender/Perentie

Single Horn, Defender/Perentie

$19.00
Single horn normally fitted to all Defenders, all County, and all Perenties. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you with the same or...
300Tdi/V8 Expansion Tank

300Tdi/V8 Expansion Tank

$85.00
Plastic coolant expansion tank for all 200Tdi and 300Tdi Defenders. Also suits all Discovery 1 and Range Rover Classic (from approx. '90). Replacement cap for this reservoir is NTC7161 *** Specific Brand Part *** This product is not specific to one brand...
3/8"UNF Propshaft Nyloc Nut (Low Profile)

3/8"UNF Propshaft Nyloc Nut (Low Profile)

$1.00
The oft-abused propshaft nut. These days usually seen as a rounded off and burred lump of steel hidden by the uni-joint. These nuts used to be a 3/8"UNF nyloc nut, but years of abuse with metric spanners tends to round them off (a 15mm spanner will not...
Upper Rear A-Frame Nut

Upper Rear A-Frame Nut

$3.85
Upper a-frame to chassis nut (3/4"UNF) for Range Rover Classic, Discovery 1, 110 County, Defender and 4x4 Perentie. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific...
Nut, 5/8"UNF

Nut, 5/8"UNF

$3.85
Suits various suspension bolts on Genuine Land Rovers. Usually suits front radius arm bolts and rear trailing arm lower bolts *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a...
Radius/Trailing Arm M20 Nyloc Nut

Radius/Trailing Arm M20 Nyloc Nut

$3.85
Nyloc nut to suit the chassis end of the front and rear trailing arms/radius arms. Suits RRC from '86, all Disco 1, all Defender/110 and 6x6. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...
Sway Bar Link Bolt, Stepped

Sway Bar Link Bolt, Stepped

$5.50
The stepped sway bar link bolt for the front and rear anti-roll bar. Connects the ball joint link to the sway bar with the rubber bushes 552819. Suits Defender, 110, Discovery 1 and Range Rover Classic.  Also suits the front and rear sway bar links...
Front Radius Arm Bush (Diff End)(Narrow Bush), >KA

Front Radius Arm Bush (Diff End)(Narrow Bush), >KA

$13.65
Narrow front radius arm bush for Defenders and 110 (inc Perentie 4x4 and 6x6) up to about '93. This is the 2-Tube type listed in most parts catalogues. We actually recommend using NTC1774 (a 3-tube type)for this application. These two numbers are...