Rubber exhaust mount for all Perentie exhausts. Two of these bushes are required for each mount. Also suits early Range Rover Classic models. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...

Single leg pipe or hose clip. Suits 8mm diameter pipes. Usually used for fuel pipes in many Land Rover models going back to Series models. Used in Perenties, Range Rover Classic, Defender and Discovery. *** Specific Brand Part *** This product is not...

Original Facet fuel pump for the carburettored Range Rover Classic. Also suits the Series 2A and Series 3 with the 2.6 6 cylinder engines. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...

Spacer for exhaust mount bush 572166. Suits all Perentie models and some Range Rover Classic models.*** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may...

Suits the Perentie exhaust mounts, but also used on the Range Rover Classic. 2X per mount. Requires the steel sleeve in the centre to prevent over-compression.*** Specific Brand Part *** This product is not specific to one brand. If the product photo...

Suits early type Rover 3.5 V8 exhaust manifold (carburettered models) *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you with the same or similar...

The cartridge type fuel filter for all carburetted 3.5V8 engines in the Range Rover Classic and Stage 1 Series 3 V8. Also suits the 2.6 6 cylinder Series 3 models. The bowl for this filter is usually blue. *** Specific Brand Part *** This product is not...

Large diameter in-line fuel filter for the early EFI Range Rover Classic (up to approx. 1990). This filter has the barb hose clamp fittings. If yours has threaded fittings use ESR4065.*** Specific Brand Part *** This product is not specific to one...

Round air filter to suit the EFI Rover V8 in the Range Rover Classic from '86 to approx. '93, and the 3.5V8 Discovery 1. This filter fits the round steel air cleaner assembly. *** Specific Brand Part *** This product is not specific to one brand. If the...

8mm (or 5/16") olive for the fuel line connections on the 300Tdi engines. Usually needed when replacing the lift pump on the 300Tdi (used with nuts NRC9770). Two required per pump.*** Specific Brand Part *** This product is not specific to one brand...

This nut is most commonly used when replacing 300Tdi lift pumps. Two are required; as well as two olives NRC9771. These sometimes come with the lift pump, but usually not. These nuts have also been used for fuel line connections on some carburetted 3...

Small diameter inline fuel filter for all Discovery 1 V8 models, and the later Range Rover Classic models. Also fits Range Rover P38A V8 petrol models. This filter has screw in fittings; if yours has hose clamps use STC1677 *** Specific Brand Part ***...

The correct hanging type rubber exhaust mount for many Genuine Land Rover models. Easy to fit, and far superior to the cable tie you just found on the garage floor. *** Specific Brand Part *** This product is not specific to one brand. If the product...

Flat panel air filter for all Discovery 1 models from VIN MA onwards (3.9V8 and 300Tdi). Also suits the last of the Range Rover Classic with the 3.9V8.  DOES NOT fit 200Tdi or 3.5V8. OE quality Coopers or Mahle *** Specific Brand Part *** This...

Twin flat panel type air filters found on early Range Rover Classics (de-tox models; usually post '76). These filters mount separately to each carburettor. 2x required per vehicle. *** Specific Brand Part *** This product is not specific to one brand. If...

Twin oval type air filters found on early Range Rover Classics with the oval type air filter BEHIND the carburettors. 2x required per vehicle.*** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...

Flame trap to suit the carburettor model 3.5 Rover V8 as fitted to the Range Rover Classic and V8 110 County. One required for each rocker cover.*** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...