Perentie and 110

Perentie and 110

Sort by

LT95 Intermediate Bolt O-Ring

LT95 Intermediate Bolt O-Ring

$4.35
O-ring for the inside of the rear support boss for the intermediate shaft in the LT95A (military) gearbox. This seals the bolt AYG3388. The outer o-ring is 532323. *** Specific Brand Part *** This product is not specific to one brand. If the product...
Tie Rod End LH Thread

Tie Rod End LH Thread

$43.00
Top quality Lemforder tie rod end with LEFT HAND thread. Fits one end of the track rod (one required per vehicle except Discovery 1 and late Range Rover Classic needs two). Fits 4x4 and 6x6 Perenties. Also fits all coil sprung Genuine Land Rovers with...
Tie Rod End RH Thread

Tie Rod End RH Thread

$49.01
Top quality Lemforder tie rod end with RIGHT HAND thread. Fits the left hand end of the drag link and one end of the track rod (two required per vehicle). Fits 4x4 and 6x6 Perenties. Also fits all coil sprung Genuine Land Rovers with live beam axles...
Front/Rear Indicator Assembly - Amber

Front/Rear Indicator Assembly - Amber

$22.00
Original amber 73mm indicator as fitted to all 110 County and Defender up to 1994. Also suits all Perentie models. This light has the two fly leads with bullet type connectors. Can also be used on the rear. If your model has the direct fit plug and...
Front Park Light Assembly - Clear

Front Park Light Assembly - Clear

$22.00
Original clear 73mm park light as fitted to all 110 County and Defender up to 1994. Also suits all Perentie models. This light has the two fly leads with bullet type connectors. If your model has the direct fit plug and separate bulb holder you need...
CV Joint Snap Ring, suits AEU2522

CV Joint Snap Ring, suits AEU2522

$2.90
The snap ring that fits to the outer end of the front inner axles to retain the CV joint. This one suits the 23-spline AEU2522 CV joint usually found in Perenties and Defender/110's up to approx. '92 (but often found as an upgrade in many later models)...
Defender/110 Steering Damper

Defender/110 Steering Damper

$66.72
OE quality replacement steering damper for all Defenders, all Perenties and all 110 County models. If you have a steering shimmy or shudder it is more than likely the issue is with your panhard bushes or swivel pin pre-loads. That said steering dampers...
Hub Oil Seal

Hub Oil Seal

$17.00
This is the only inner hub seal worth using on any Genuine Land Rover. This is a double lip and double spring design made especially for oil filled hubs. Fits all coil sprung live beam Genuine Land Rovers up to and including the Puma Defender. Fits all...
Wheel Bearing

Wheel Bearing

$40.00
OE Timken single wheel bearing to suit all Range Rover Classic, all Discovery 1, all Defender and 110 up to 2017, and all Perentie 4x4 and 6x6. Suits inner and outer, front and rear (2x required per hub). *** Specific Brand Part *** This product is not...
LT95 Layshaft Bearing

LT95 Layshaft Bearing

$42.20
Tapered roller bearing for the front and rear of the LT95 layshaft. Suits all versions. The preload MUST be set correctly for these bearings. Follow the workshop manual to set this correctly. DO NOT assume the existing shims are correct.    ...
Snail Cam Brake Adjuster Kit

Snail Cam Brake Adjuster Kit

$24.35
Replacement snail cam brake adjusters for most Genuine Land Rover drum brakes. Suits SWB and LWB including Perentie rear drum brakes. Comes with fitting instructions.*** Specific Brand Part *** This product is not specific to one brand. If the product...
Rover Diff Carrier Bearing (Late Metric)

Rover Diff Carrier Bearing (Late Metric)

$65.00
Suits front and rear Rover type diffs in Discovery 1, Discovery 2, and Range Rover Classic from approximately '92 on. Also suits front Rover diffs for Defenders from '92 on. Also suits front and rear diffs in the Range Rover P38A, and the rear diffs for...
Salisbury Diff Cover Gasket

Salisbury Diff Cover Gasket

$7.70
Paper gasket for the Salisbury diff rear cover. We fit these by applying a liberal layer of Ultra Black to both sides of the gasket. We fit the cover in place over the gasket and fit all of the bolts. BUT don't do them up. Take them up to just hold...
Plain Wheel Nut (Steel Wheels)

Plain Wheel Nut (Steel Wheels)

$3.20
Plain steel wheel nut to suit all 110, Defender, Perentie, RRC and Discovery 1 with steel wheels. M16 thread. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we...
SEAL, DOOR TOP

SEAL, DOOR TOP

$44.00
Rubber sealing strip that fits under the sliding window door top on the 4x4 Perentie. Also suits Series III. You may also need the two studs VYR500010. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or...
Front Shock Tower Retaining Ring

Front Shock Tower Retaining Ring

$11.90
Retaining ring with studs for the front shock absorber tower. With some age on these rings we are now seeing a lot of failures - usually the studs either stripping or breaking off. Suits all Range Rover Classic, all Discovery One, all Defenders, all 110...
A-Frame Ball Joint (Upper Rear)

A-Frame Ball Joint (Upper Rear)

$75.00
Non-adjustable Lemforder (German) a-frame ball joint. Top quality replacement ball joint for all Range Classic, all Defender and 110 up to 2017, all Discovery 1, and all 4x4 Perentie. For an adjustable version see RHF500110ADJ. NOTE: If you buy this with...
Adjustable A-Frame Ball Joint

Adjustable A-Frame Ball Joint

$84.00
Rear A-Frame upper ADJUSTABLE ball joint fitted to the top of the rear diff. Fits all coil sprung Genuine Land Rovers with live beam axles (all 110, Defender, Range Rover Classic, Discovery 1). The locking stakes are tapped back to allow adjustment and...
Ignition/Steering Lock Clamp

Ignition/Steering Lock Clamp

$22.00
Mounting clamp for the steering/ignition lock assemblies found on pretty much all 110 and Defender models. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may...
Ignition/Steering Lock Kit 110/Perentie

Ignition/Steering Lock Kit 110/Perentie

$150.00
Direct fit ignition barrel/steering lock for the Perentie 4x4 and 6x6. No wiring modifications are required. Includes mounting clamp QRG100100 (no extra cost; this is usually a separate part). This barrel is more expensive than the cheap barrel that can...