Single brake pipe clip (as in single pipe). Suits many models across the Land Rover range. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you...

This particular nut is used across a wide range of not just Land Rover models, but many other early British cars. A thin style large fine thread nut (and we know that isn’t a technical dimension but it is the most common description our customers...

Caliper bridge seal (between the two halves of the caliper).  Suits Range Rover and Discovery 1 calipers.  Suits rear calipers on Perentie 6x6 and RFSU models. *** Specific Brand Part *** This product is not specific to one brand. If the...

The slender brass nut for mounting and locking the brake switch. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you with the same or similar part...

“P” Clip for the rear brake pipes fitted to the rear axle. Suits most coil sprung Land Rover models to ‘99 including Perentie and Range Rover Classic. Two per vehicle. *** Specific Brand Part *** This product is not specific to one...

Suits 41mm pistons. Each kit will do 4 pistons. So you need one kit for each front caliper. And one kit for BOTH rear calipers. Each kit contains 4x seals, 4x wiper seals and 4x retaining rings. Suits the following models: All Perentie 4x4 and 6x6 rear...

Suits all Range Rover Classic to approximately 1985. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you with the same or similar part of a...

Suits Perenties, Defenders and Range Rover Classic *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you with the same or similar part of a...

Front caliper piston for all Perentie models. Also suits Defender front calipers. If your pistons measure 46mm diameter these pistons will fit. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...

Calliper bleed screw for Defender, Perentie, Disco 1, and Range Rover Classic. DOES NOT suit the wheel cylinders fitted to drum brakes. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description...

Used on many Land Rover models for the brake pipes. Usually 3x required; just replace as necessary.*** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may...

Single pipe clip to suit a number of applications:Clutch pipe on Defenders and Perentie;Bonnet prop clip for Defenders;Breather pipe clip; andFuel line clips. *** Specific Brand Part *** This product is not specific to one brand. If the product photo...

Brake pad spring kit to suit the rear calipers on al 6x6 Perentie and RFSU/SRV models. Also suits the front callipers for all Discovery 1 and Range Rover Classic (from approx '88)(with solid retention pins).Used with solid rentention pins RTC5001. DOES...

Suits NON-VENTED Discovery 1 and Defender front brakes. Suits rear brakes for 6x6 and RFSU/SRV Perentie models. DOES NOT suit early split-pin type callipers. Use with pad spring kit STC8576. *** Specific Brand Part *** This product is not specific to one...

Handbrake shoe return springs for all Perentie LT95 handbrakes; also fits LT230 variants with an indirect handbrake cable. NOTE: These springs are fitted vertically; if yours are horizontal these will not fit.*** Specific Brand Part *** This product is...