Gearbox, Transfer Case and Winch

Gearbox, Transfer Case and Winch

Browse by

Brands

Shop by Brand

Price Filter

Shop by Price

Sort by

Mainshaft Bearing, LT95

Mainshaft Bearing, LT95

$195.00
Mainshaft bearing for the LT95 4-Speed gearbox. Suits all variants of the LT95 including Range Rover Classic, Perentie and 101FC. 2x per gearbox. Genuine RHP bearing. *** Specific Brand Part *** This...
Add to Cart
LT95 Gearstick Stepped Bolt

LT95 Gearstick Stepped Bolt

$5.60
The stepped bolt for securing the LT95 gearstick (three required per vehicle). *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description...
Add to Cart
LT95 Oil Filter/Screen

LT95 Oil Filter/Screen

$6.00
Plastic tube type oil screen fitted behind the drain plug on all versions of the LT95. Also fitted to the LT77/LT77S gearboxes fitted in Defender, Discovery 1 and Range Rover Classic. *** Specific...
Add to Cart
LT95 Vacuum Actuator O-Ring

LT95 Vacuum Actuator O-Ring

$2.00
O-ring to seal the vacuum actuator shaft in its housing. Suits only LT95 gearboxes. Vacuum actuators are often mis-diagnosed as faulty when it is only this o-ring at fault. Make sure you test these...
Add to Cart
Speedo Drive O-Ring

Speedo Drive O-Ring

$2.00
O-ring to seal the speedo drive insert into the rear output housing. Suits LT95 and LT230. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...
Add to Cart
LT95 Mainshaft Needle Roller Bearing (Rear)

LT95 Mainshaft Needle Roller Bearing (Rear)

$37.60
Needle roller bearing for the rear of the mainshaft in all versions of the LT95. This fits in the PTO plate on the rear of the transfer case (or in the 3rd axle output of the 6x6). *** Specific Brand...
LT95 Oil Pump Housing Gasket

LT95 Oil Pump Housing Gasket

$8.80
The gasket for the cast iron oil pump housing/input seal housing for all versions of the LT95 gearbox. This gasket is included in our Perentie clutch kit KLR-CK4. Also included in the LT95 gasket...
Add to Cart
LT95 Mainshaft Snap Ring (Front)

LT95 Mainshaft Snap Ring (Front)

$22.00
Special snap ring for the front of the mainshaft to retain the 3rd/4th synchro assembly. Suits all LT95 gearboxes. Before you fit this ring grind each end on an angle to make it easier to remove...
LT95 Mainshaft Front Roller Bearing

LT95 Mainshaft Front Roller Bearing

$47.94
Roller bearing that fits on the front end of the mainshaft into the rear of the input shaft. Suits all LT95 gearboxes. 1x per gearbox. *** Specific Brand Part *** This product is not specific to one...
LT95 Input Shaft Seal

LT95 Input Shaft Seal

$17.00
Corteco brand (good stuff) oil seal fitted in the rear of the oil pump housing on the LT95 input shaft. Unless you like removing gearboxes don't risk a cheap oil seal here. This seal is included in...
Add to Cart
LT95 Reverse Idler Shaft O-Ring

LT95 Reverse Idler Shaft O-Ring

$22.00
Seals the back of the reverse idler shaft into the transfer case. Suits LT95 and LT95A gearboxes. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or...
Add to Cart
LT95 Intermediate Shaft O-Ring

LT95 Intermediate Shaft O-Ring

$4.20
O-ring to seal the rear of the intermediate shaft on the LT95 and LT95A transfer case (roller and taper bearing types). *** Specific Brand Part *** This product is not specific to one brand. If the...
Add to Cart
LT95 Front Output Bearing

LT95 Front Output Bearing

$54.51
Front output bearing for the LT95/LT95A gearbox (where the front propshaft connects). *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...
Add to Cart