Engine and Drivetrain

Engine and Drivetrain

Sort by

Water Pump Bolt, M10x55 (1.25mm), 4BD1

Water Pump Bolt, M10x55 (1.25mm), 4BD1

$2.75
Water pump bolt for most versions of the 4BD1. This is a FINE thread metric bolt – 1.25mm pitch. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or...
1/4" BSPT Weld-On Fitting

1/4" BSPT Weld-On Fitting

$3.85
Generic 1/4”BSPT weld-on fitting. Mainly used for EGT probes, but can also be used for oil, coolant and diesel fittings. *** Specific Brand Part *** This product is not specific to one brand. If the...
Diff Centre Stud, 3/8UNF

Diff Centre Stud, 3/8UNF

$5.39
Diff case stud fitted to the axle case. Suits front and rear of Range Rover Classic, Discovery 1 and 2. Suits front of all Perentie and Defender models to 2016. 3/8ÜNF x 1 ¼”. Usually two per diff,...
Tee Piece, Brass, 3/16"

Tee Piece, Brass, 3/16"

$4.95
Normally used for the vacuum lines to the 6x6 Perentie diff lock and rear axle controls. But can be used anywhere a brass tee piece is required. *** Specific Brand Part *** This product is not...
Rear Output Housing, LT95A (Refurbished)

Rear Output Housing, LT95A (Refurbished)

$200.81
$150.00 On Sale
Rear output housing for Perentie and 110 County versions of the LT95 (big handbrake drum). DOES NOT suit Range Rover Classic. *** Specific Brand Part *** This product is not specific to one brand. If...
Swivel Pin Kit, 110/Defender to '92

Swivel Pin Kit, 110/Defender to '92

$64.00
Swivel pin and bearing kit for all Perentie 4x4 and 6x6 models.  Also suits all Defender models up to approximately '92.  Includes the top Railko type housing and pin and a selection of shims.  Also...
Aftermarket Wheel Bearing Kit

Aftermarket Wheel Bearing Kit

$48.40
Quality aftermarket wheel bearing kit to suit MANY Land Rover models. Includes two bearings, one hub seal (grease type), drive flange gasket, two types of hub nuts and lock washer. One kit required...
Cover, RH Engine Mount, Perentie

Cover, RH Engine Mount, Perentie

$27.50
Engine mount protection cover for all Isuzu 4BD1 engines. Suits 4x4 and 6x6 Perenties. This cover protected the rubber mount from diesel and power steering fluid, preventing premature deterioration...
Camshaft Bearing, 4BD1, (2 Required)

Camshaft Bearing, 4BD1, (2 Required)

$22.87
$15.00 On Sale
Camshaft bearing for all Isuzu 4BD1 engine including turbo models. 2X of this bearing required per motor. *** Specific Brand Part *** This product is not specific to one brand. If the product photo...
Oil Pressure Relief Valve

Oil Pressure Relief Valve

$16.50
$8.25 On Sale
*** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you with the same or similar part of a...
Oil Cooler, 4BD1 NA (Cooler Only)

Oil Cooler, 4BD1 NA (Cooler Only)

$132.00
$50.00 On Sale
Engine oil cooler. Suits 4BD1 NA (4x4 Perentie) models only. *** Specific Brand Part ***This product is not specific to one brand. If the product photo shows or the description lists a specific...
Nyloc Nut, M16

Nyloc Nut, M16

$3.85
Used for later model Radius arm and trailing arm bolts. Also suits the panhard rod bolts on Defenders ‘02>. *** Specific Brand Part *** This product is not specific to one brand. If the product photo...