The sway bar/anti-roll bar link as fitted to Defender, 110, some Perentie, Disco 1, RRC. One end of this link looks like a tie-rod end. Two per axle, and these are the same front and rear. Uses two rubber bushes 552819 per link. *** Specific Brand Part...

OE Metalastik type bush for the rear upper a-frame to chassis mount. Suits the rear of all Range Rover Classic, all Discovery 1, all Defenders, and all 110 models including 4x4 Perentie. The old bushes must be pressed out and these new ones pressed in...

Original style rubber/steel bush for the diff end of the rear trailing arm. Suits most coil sprung Genuine Land Rovers - RRC, Disco 1, Defender, 110 and Perentie 4x4. *** Specific Brand Part *** This product is not specific to one brand. If the product...

Cup type shock absorber guide washer. Normally fitted to the top and bottom of the front shocks in all Defenders/110, Discovery 1, Range Rover Classic and Perenties. These are often supplied with various shock absorbers, but not always. *** Specific...

Rear swaybar (or anti-roll bar) "D" bush to suit all rear Defenders including Puma models. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a specific brand, we may provide you...

One-piece upper rear shock absorber bush for Range Rover classic, Discovery 1, Defender and Perentie models. This bush has a steel insert in the middle. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or...

Aftermarket rubber "donut" style bush that fits the rear of the front radius arms. Four required per vehicle. Fits all 110, Defender and Discovery 1 and also fits all Range Rover Classic from approximately 1986. Also fits 4x4 and 6x6 Perentie. We...

Black plastic column shroud for all Defenders and 110. This is the lower half and is fixed with self tapping screws (earlier versions used M5 screws but supersedes to this part). The upper half is LR048112. *** Specific Brand Part *** This product is not...

Black plastic column shroud for all Defenders and 110. This is the upper half and is fixed with self tapping screws (earlier versions used M5 screws but supersedes to this part). The lower half is LR048223. *** Specific Brand Part *** This product is not...

The "Bar, Tie, Bent Forging" (Genuine Land Rover's words, not ours) from the bottom of the steering box to the panhard rod mount. The early ones had slots instead of holes. These often break; the later one has holes and has proven to be much stronger...

Nominal 2" raised front spring for all Defender models from 1991 on. Suits 200/300Tdi, Td5 and Puma models.  Will also suit the front of a diesel Discovery 1 with a bullbar and winch.   A good all-round option for the front of any of...

Rear King springs for Defender or Perentie 4x4 with a consistently higher tare weight (nominally 300kg above standard tare). Lifts roughly 2" above STANDARD height; closely matches the height of the original 4x4 Perentie rear spring.  Good match for...

Rear King springs for Defender 110 to 2016 or Perentie 4x4. Lifts roughly 2" above STANDARD height; closely matches the height of the original 4x4 Perentie rear spring but slightly heavier.  Good match for a Defender 110 station wagon loaded for...

M14 bolt for either end of the panhard rod on all 110/Defender/Perentie/Discovery 1 and later Range Rover Classic. Suits the ANR3410 panhard bush. On older vehicles in particular these usually need to be replaced when the bushes are replaced. Any wear on...

BACK IN STOCK!!!! Bilstein steering damper to suit all Defender models, all 110 County models, and all Perentie 4x4 and 6x6 models. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists...

Aftermarket rubber bush for the rear of the front radius arm for all TD5 and Puma Defenders. We recommend using TF1003 for this application. *** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the...

Genuine Land Rover panhard rod bush. Suits all 110/Defender and Perenties. Also suits all Discovery 1 and all Range rover Classic from approximately 1984 on. This is the genuine Land Rover bush; no other brand appears to be worth fitting, particularly in...

The 2-hole lock tab normally fitted to the mounting bolts for the 3- and 4-bolt power steering boxes. Suits all Range Rover Classic, all Discovery 1, all Defenders and all Perenties (including those with manual steering boxes). Two per vehicle. These can...

Chassis end steering damper bush for all Defender/110/Perentie. 2x per vehicle. Will also suit most aftermarket steering dampers.*** Specific Brand Part *** This product is not specific to one brand. If the product photo shows or the description lists a...

Shock absorber bush for 110/Defender/RRC and Disco 1. Fit front shocks upper and lower and rear shocks lower. Note: On the later models your rear axle may have cups welded to the lower shock mount. If it does you need shock bushes part number RNF100090L...